DiskMend

Updated 2026-11-15 · 5 min read

Recover Files Before Running CHKDSK (Why CHKDSK Can Erase Data)

Running chkdsk /f on a corrupted drive often turns personal files into .CHK fragments. Learn why you should always recover files with a read-only tool first.

When a hard drive or USB drive starts acting up, common internet advice is to run `chkdsk /f` or `chkdsk /r`. While CHKDSK is a capable Windows file system consistency utility, it is emphatically not a data recovery tool.

CHKDSK prioritizes making the file system bootable and clean for Windows. If an index pointer or directory entry is corrupted, CHKDSK often deletes the reference or chops the file into unindexed `FOUND.000` / `FILE0001.CHK` fragments, destroying the original file names and folder structures.

What CHKDSK Actually Does to Corrupted Files

When CHKDSK encounters a corrupted Master File Table ($MFT) record or broken cluster chain, it does not attempt to reconstruct your original file contents. Instead, it marks the cross-linked cluster as free or detaches the damaged record.

The result: your files disappear from File Explorer, and any recoverable remnants get dumped into a hidden folder named FOUND.000 as generic .CHK files.

The Golden Rule: Never Run Repair Tools on Failing Drives

If a drive has bad sectors or failing NAND flash memory, the heavy read-write stress of a full `chkdsk /r` scan can push the hardware over the edge, causing total controller failure.

A modern data recovery engine works in pure read-only mode, bypassing Windows write calls completely.

How to Safely Recover Data First

Before running any command prompt commands, launch DiskMend. DiskMend reads the drive sequentially, salvage-reads difficult sectors without looping infinitely, and extracts files onto a separate, healthy drive.

Step by step

  1. 1

    Stop running CHKDSK

    If a CHKDSK scan is scheduled or prompted by Windows, cancel it before it begins writing.

  2. 2

    Open DiskMend

    Select the affected volume or drive in DiskMend's device list.

  3. 3

    Extract existing and deleted files

    Allow DiskMend to catalog intact directory trees and carve raw signatures.

  4. 4

    Verify file integrity

    Check photo previews and each file’s intact or partial status before saving.

  5. 5

    Run CHKDSK only as a final repair

    Once files are backed up safely, run `chkdsk /f` to repair file system errors.

CHKDSK vs. Read-Only Data Recovery
FeatureWindows CHKDSKDiskMend Data Recovery
Primary GoalMake file system consistent for WindowsExtract personal files safely
Disk WritesYes (Alters sectors & directory tables)Zero writes (Strict read-only)
Folder StructureOften detaches broken foldersPreserves original names & paths
Hardware SafetyStresses failing drives with write cyclesGentle read salvage algorithm

Frequently asked questions

Can CHKDSK permanently delete files?+

Yes. When CHKDSK detects index corruption or cross-linked clusters, it frequently deletes the file record or isolates the data blocks into .CHK files without confirmation.

What should I do if CHKDSK is already running?+

Do not abruptly yank the power cable or pull the USB drive while CHKDSK is writing, as that can cause electrical or partition damage. Wait for it to finish, then immediately scan the drive with DiskMend.

Can DiskMend recover files already turned into .CHK files?+

Partly. The .CHK files themselves are listed like any other file and can be saved. DiskMend does not turn .CHK fragments back into named files, but it reads deleted records and searches free space by content, so files whose data CHKDSK released can often still be found.

Guides

More guides

Guides →